The Challenges to Swim Spa Covers

Swim Spas represent distinct challenges when it comes to covering them.
We can all agree that the swim spa has to be covered when not in use for all the same factors a hot tub needs a cover. The obstacle is that because of the length of the swim spa and the height of the sides, eliminating and replacing the cover can be a lot more difficult.
Getting a new swim spa is an amazing event in life. You’re anticipating the exercise you’ll get from using it. Possibly you’re a little relieved to have lastly selected from the various models you looked at. At any rate, you most likely weren’t thinking much about the cover you would use.
Usually, the cover that comes home with your new purchase will be a 4 section stiff foam filled cover that will split in the center and go off both ends.
No big deal.
Until it begins to get heavy.
Which it always does.
Every stiff foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a style defect. Built in obsolescence since as soon as it is put in use over the warm water in your swim spa it is inevitable.
It’s not from rain, so having a taper will not make any distinction. In fact you could have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The molecules of steam are very little as they increase from the water surface area. They make their way into the little cracks and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes caught in the cover.
It occurs slowly and on a Swim Spa Cover which is made of specific sections, at varying speeds. So eventually you’ll observe one or two of the sections are really getting heavy. The bar lifters on completions of the swim spa aren’t much aid due to the fact that you still have to lift that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com developed a different design for their Swim Spa Covers
Instead of using a number of foam panels to construct Swim Spa Covers that will eventually end up in some landfill, they developed one that utilizes air chambers that don’t suck up moisture.
In fact SpaCap.com Swim Spa Covers are light-weight, insulate better, won’t blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine fabric, these covers will not fade, or fall apart at the seams either. So if you own a swim spa, and you intend to keep using it everyday, SpaCap.com has the Swim Spa Cover for it.
If you’re not ready to order today, bookmark this site so you can find it again when you’re all set!

Leave a Reply

Your email address will not be published. Required fields are marked *